Projector to Bluetooth speaker: where B66 connects
Trace the sound from your HDMI source to the projector’s analog Audio Out, then to B66 in TX mode. Check the output before buying a Bluetooth transmitter.
Follow the movie audio, not just the picture
A picture on the wall does not establish that sound is reaching a Bluetooth speaker. For a projector with a suitable analog output, the proposed path is video source → projector Audio Out → B66 in TX mode → compatible Bluetooth speaker. B66 takes the wired audio signal and sends it over Bluetooth. It does not plug into HDMI or extract sound from an HDMI cable. Before ordering, find the projector’s actual audio output and check that its manual supports output from the source you plan to watch.
In this guide · 6 sections
Read the output label in the projector manual
Look for an analog socket identified as Audio Out, rather than assuming every 3.5 mm or red-and-white connection sends sound out. Epson’s Home Cinema 880/1080 Quick Setup illustrates the distinction: HDMI carries the video source’s audio into the projector, while a separate Audio Out feeds self-powered speakers. On the 1080, the red-and-white audio sockets shown beside composite video are inputs. That example helps identify the direction of the connections; it is not a B66 compatibility test or a claim that every Epson projector has the same ports.
Check the wired output before pairing the speaker
Play a short clip from the source you will actually use, with the correct projector input selected and its sound unmuted. If you already have self-powered speakers and a cable suitable for the projector’s analog output, try that wired connection first at low volume, following the projector manual. Sound there confirms that the selected source can reach that output before Bluetooth enters the setup. If the wired speakers stay silent, check the source’s audio-output selection and the projector’s settings before repeating Bluetooth pairing. For Epson’s 880/1080 example, the manufacturer notes that connecting external speakers disables the built-in speaker; silence from that internal speaker alone is not proof of a fault.
Connect B66 as a transmitter
Connect the suitable analog output to B66’s AUX/RCA audio input for TX operation and provide USB-C 5V power. B66’s supplied materials identify TX with a red indicator; RX, shown in blue, is for receiving phone music into wired audio equipment. Choose TX for this projector-to-Bluetooth-speaker path. Put the speaker into pairing mode using its own instructions, and check whether it is still connected to a phone. The intended wireless link is B66 to the speaker. B66’s USB-C connection supplies power, so it does not take the place of the audio cable from the projector.
If there is no analog output, stop at the connection plan
An HDMI socket, even one marked ARC, is not a direct connection to B66. Neither is an optical-only output. Do not buy a simple cable with matching-looking ends and expect it to create the analog signal B66 needs. Check whether the video source itself has a suitable analog output, or whether your projector or source already supports sending audio directly to your Bluetooth speaker. Those are different routes to confirm in their manuals. Any additional conversion device would need its own connection and format checks; it is not included in this B66 setup.
Use a dialogue scene for the final check
Once you hear the soundtrack, play a scene where someone is visibly speaking. Check it from the seat where you will watch, using a comfortable listening level. B66 latency and codec behavior have not been independently measured here, so a successful connection is not a promise of lip sync. If sound is late, cuts out or remains missing, record the projector model, video source, Bluetooth speaker model and exact socket used. Include whether a wired speaker worked on that output. That gives a useful starting point for support without assuming that pairing, the source feed and picture-to-sound timing are the same problem.