TV remote won't change headphone volume? Check the output feeding B66
Sound reaches your Bluetooth headphones, but the TV remote does not change its level. Check fixed, variable and headphone output settings in a B66 setup.
A moving volume bar does not identify the output being adjusted
The program is audible through your Bluetooth headphones, yet pressing the TV remote changes the on-screen number without changing what you hear. Start with the TV's audio output setting, rather than pairing everything again. In this B66 setup, sound travels from the TV's analog output into B66, then wirelessly to the headphones. The TV may be adjusting its room speakers while leaving that wired feed unchanged. Keep the same short program segment playing so you can compare one control at a time.
In this guide · 6 sections
A fixed output leaves listening volume to the receiving equipment
Sony's linked setup guide describes Audio out (Fixed) as a constant-level TV output, with volume adjusted on the connected audio system. In a headphone setup, check whether the headphones provide their own usable volume control. Consult their instructions for the button or touch gesture; do not assume a play/pause control also changes volume. If the TV is sending a fixed feed, an unchanged headphone level after pressing the TV remote is consistent with that setting. It does not by itself show that the transmitter has lost its connection.
A variable output may let the TV remote adjust the feed
For TVs covered by Sony's audio-system guide, Audio out (Variable) lets the remote adjust the analog output sent to the external device. That is a TV-side setting, not a new Bluetooth pairing procedure. Look up the exact TV model before following a menu path from another set. If its manual offers a variable output, check whether that is the intended option for the socket you are using. The Sony references illustrate the distinction; they do not establish that every TV offers both choices or that a particular TV has been tested with B66.
Check for a separate headphone level before changing modes
A menu can contain more than one volume setting. Sony's setup example lists Headphone Volume separately and says it is unavailable when certain Audio Out modes are selected. Use the instructions for your TV to identify which setting applies to its connected socket. Before changing an output mode, take the headphones off and lower their own level where possible. Follow any instruction to disconnect the plug before changing the setting. Resume at a low level, then adjust gradually; the previous comfortable setting is not a reliable starting point after changing modes.
Keep the analog cable path in view
B66 needs a compatible TV 3.5 mm headphone or analog RCA audio output, plus USB-C 5V power. Use TX for the headphone connection; the supplied materials identify it with a red indicator. RX is the separate job of receiving phone music into wired equipment. B66 has no direct HDMI or optical socket, so instructions for an HDMI-connected soundbar describe a different connection. Likewise, pairing headphones directly to a TV uses the TV's own Bluetooth feature, not this external transmitter. Write down the actual output label instead of relying on the shape or color of the plug.
Confirm a practical volume control before choosing the setup
For an existing installation, note whether the TV remote, a separate headphone menu or the headphones' own controls change the listening level. If none does, send the TV and headphone model numbers, a photo of the output label and the current audio-output setting before buying another cable. For a new setup, establish where volume will be controlled before ordering B66. A fixed TV output paired with headphones that lack a usable volume control needs further checking. If other people will hear the room speakers too, use the shared-listening guide below: simultaneous output and dialogue timing are separate questions, and B66 has no independently verified lip-sync guarantee.