Bluetooth stereo keeps cutting out? Checks for B35 and B66
Compare downloaded audio, phone placement and the wired connection when B35 or B66 RX playback breaks up. Change one condition at a time before replacing equipment.
Keep a repeatable example of the interruption
A song plays through the stereo, then loses a word or goes quiet for a moment. Before changing cables, choose a short passage you can replay and note where the phone is sitting. Check whether the app pauses or shows a loading message, whether Bluetooth still says connected, and whether both speakers lose sound together. Those are different observations. This guide is for phone music received by Home B35 or B66 in RX mode; B66 transmitting TV sound to headphones is a different signal path.
In this guide · 6 sections
Compare a saved track with a stream
Try audio already downloaded to the phone, keeping the phone, receiver and volume in the same positions. Confirm in the app that the file is available for offline playback. Apple uses stored-versus-streamed audio as a troubleshooting comparison in its wireless-headphone guidance. Here it is a way to reduce reliance on a live internet feed, not an Apple compatibility endorsement for B35 or B66. If saved audio plays cleanly but the stream breaks up, investigate the streaming app and its network connection next. That result alone does not identify a faulty router or prove the receiver is fault-free. The file stays on the phone for this check; you do not need to test B35's separately documented USB playback feature.
Bring the phone closer before moving the whole stereo
Replay the saved passage with the phone near the receiver and with a clear path between them. If it normally sits in another room, on the far side of a wall or behind a metal cabinet, make the comparison in the same room first. Apple's interference guidance recommends bringing Bluetooth devices closer together and reducing obstructions; it also identifies nearby wireless equipment and some electrical devices as possible interference sources. Try a different nearby position without changing the audio file at the same time. An improvement is useful evidence about that arrangement, not a measured maximum range or a guarantee that moving the receiver will fix every dropout.
Check the power and analog connection too
B35 sends analog audio from its AUX or RCA output to an amplifier or powered speakers. B66 does that receiving job in RX mode, shown as blue in its supplied instructions. Both need USB-C 5V power. If moving the phone does not help, lower the stereo volume and check that the power plug and audio plugs are seated. Leave enough cable slack before repositioning the receiver. Record whether its indicator disappears when the sound stops; do not assume every interruption comes from the wireless link. Keep the stereo on the input that was working, and avoid switching B66 to TX during this phone-music check.
Use a second phone as a comparison, not a verdict
If another phone is available, disconnect the first one before connecting it. Play the same saved clip if you can, using the same receiver position and stereo input. The related phone-switching guide covers that handover without assuming multipoint support. If only one phone has the problem, note its model, software version and app before buying a replacement receiver. If both behave alike, the shared power, cable, stereo input and room arrangement still need consideration. Neither result by itself proves which component is defective. Avoid resetting every device at once; that removes the working setup you were using for comparison.
Describe the pattern when asking for help
Useful notes include whether the interruption occurs with a downloaded file, whether bringing the phone closer changes it, whether the receiver stays lit, and whether a second phone produces the same result. Include the receiver and stereo models and a photo of the AUX or RCA connection. If just one speaker goes silent while the other continues, follow the left/right connection guide below instead. B35 and B66 range and dropout performance have not been independently measured here. These checks help describe a repeatable problem; they do not promise a particular distance, wall penetration or interference-free playback.